You’ve spent numerous hours on bodywork and paint, your automotive’s engine is spotless, and the inside seems to be excellent…properly, aside from that cracked steering wheel. If you happen to’re in that state of affairs, you might have a number of choices: stay with the cracked steering wheel, attempt to find a very good used steering wheel, buy a replica or aftermarket steering wheel, or restore your present steering wheel. For a lot of, finding a very good used steering wheel is tough, and replica steering wheels (if out there) are expensive. This leaves you with the choices of both dwelling with a cracked steering wheel, or repairing the prevailing steering wheel.
Repairing a cracked laborious plastic or rubber steering wheel is rather a lot simpler than you would possibly assume. To make the job even simpler, Eastwood presents a number of steering wheel restoration kits that embody detailed directions.
To get began, you’ll first must take away the steering wheel, and clear it with dishwashing detergent and water. After you’ve washed it, spray with PRE Painting Prep to take away oily residue that will have come out of your pores and skin. For any cracks, it would be best to use a triangle file to “V” the crack. Tip: a Dremel-style device additionally works properly. This may help you fully fill the crack with the PC-7 Epoxy. Combine the PC-7 following the instructions on the again of the can. Barely overfill the crack with the PC-7. (Tip: moist your finger with water to easy out the PC-7.) Enable the PC-7 to dry for 24 hours.
After the PC-7 has totally dried, begin smoothing it with 240-grit sandpaper, and end with 320-grit sandpaper. Spray it once more with PRE to scrub the floor. You should definitely not deal with the steering wheel along with your naked arms, as this will likely contaminate the floor with oils out of your pores and skin. You are actually prepared to use a primer.
|Use Gray Self-Etch Primer to use a number of mild coats to easy the floor. As soon as it dries, you’re prepared to use your topcoat. The self-etching primer creates an amazing base for nearly any topcoat end (epoxies aren’t advisable). Our vinyl interior dyes work properly as topcoats over the Self-Etching primer.
Here’s a “earlier than” image of a steering wheel that we lately restored.
|Right here is the completed product. After the steering wheel was primed, it was painted with ivory white base coat, after which top-coated with a Urethane Clear Coat.|