SPRAY-PAINTING TROUBLESHOOTING | Eastwood Blog


Whether or not utilizing an aerosol can, an HVLP turbine system, or compressed air and a spray gun, one of the best ways to use automotive purposes is to spray it. Typically, nevertheless, the ultimate end doesn’t come out completely. Under are eight widespread issues, what causes them, and the way to restore the end.


Downside: Dry Spray – Dry paint mud settling over beforehand painted areas.
Causes: Paint drying too rapidly; work piece too massive to color with an aerosol; software too sluggish; spray can is just too removed from floor.
Restore: Sand with a fine-grit sandpaper, adopted by compounding and sharpening; refinish as required.

Downside: Blistering – Effervescent, pitted or swollen look.
Causes: Trapped solvents; portray over filth or moisture; rust beneath the floor.
Restore: Sand down and refinish; if needed, sand down to reveal metallic. Guarantee floor is totally clear earlier than repainting.

Downside: Runs or Sags – Coating doesn’t adhere uniformly to the floor being painted.
Causes: Paint drying too slowly; sprayed over wax, oil, or grease; ending coats too heavy; paint can or work floor too scorching or too chilly.
Restore: If moist: use camel hair brush to brush out sag, then recoat floor. If dry: sand with fine-grit sandpaper, compound and polish; or refinish.

Downside: Orange Peel – Floor seems to be just like the pores and skin of an orange.
Causes: Paint can held too far-off from the floor; store temperature is just too excessive (for finest outcomes, apply between 65°F and 75°F); spray nozzle is clogged.
Restore: Sand with 600-grit or finer sandpaper, and use a tremendous compound to rub out orange peel. If that fails, take away paint and refinish.

Downside: Spitting – Little or no paint coming from nozzle.
Causes: Nozzle obstructed or clogged; valve clogged.
Restore: Take away nozzle from can and put a number of drops of lacquer thinner within the valve. Don’t poke or decide on the valve. Soak nozzle in lacquer thinner for a number of seconds and substitute the nozzle in can with a slight twisting movement. Don’t push nozzle down into can.

Downside: Mottled Floor – Uneven look (typically impacts metallic).
Causes: Paint can’t shaken sufficient; paint can held too near floor; floor too scorching or too chilly.
Restore: Re-spray as required utilizing a swirling or rotating movement whereas spraying to deposit the metallic particles evenly on the floor.

Downside: Fish Eyes – Small crater-like blemishes within the end.
Causes: Silicone on the floor; improperly cleaned work piece.
Restore: If nonetheless moist: wash off paint. Totally clear floor utilizing Eastwood’s PRE Painting Prep. Repaint floor.

Downside: Lifting or Wrinkling – A swelling or moist movie.
Causes: Improper drying of the final coat; making use of lacquer over enamels.
Restore: Materials should be eliminated and the floor re-sprayed. Examine compatibility of topcoat and substrate coatings and primers earlier than reapplying paint.



Source link